User Tools

Site Tools


pcb_manual

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
pcb_manual [2017/07/03 19:24]
z00m [PIC Command List]
pcb_manual [2017/07/03 19:26] (current)
z00m [PIC Command List]
Line 210: Line 210:
 ==== PIC Command List ==== ==== PIC Command List ====
  
-=== Configuration-related ​===+__**Configuration-related**__
  
 **$88 + $a1**\\ ​ **$88 + $a1**\\ ​
Line 226: Line 226:
 make the current FPGA config base address permanent (IE: store it in the PIC's flashram. Note: "​Programming mode" must be enabled first)\\ make the current FPGA config base address permanent (IE: store it in the PIC's flashram. Note: "​Programming mode" must be enabled first)\\
  
-=== Databurst-related ​===+__**Databurst-related**__
  
 **$88 + $c9**\\ **$88 + $c9**\\
Line 243: Line 243:
  
  
-=== Programming-related ​===+__**Programming-related**__
  
 **$88 + $25 + $fa + $99**\\ **$88 + $25 + $fa + $99**\\
Line 264: Line 264:
 Program 64 bytes into the EEPROM (The 64KB EEPROM block in which the bytes are to be located must be erased prior to programming new data.)\\ Program 64 bytes into the EEPROM (The 64KB EEPROM block in which the bytes are to be located must be erased prior to programming new data.)\\
  
- +__**Status-related**__
-=== Status-related ​===+
  
 **$88 + $53** (added in PIC firmware v6.17 - Nov '09)\\ **$88 + $53** (added in PIC firmware v6.17 - Nov '09)\\
Line 272: Line 271:
  
 Valid bytes returned by this command:\\ Valid bytes returned by this command:\\
- 
  
 ^ID Byte^Capacity of EEPROM| ^ID Byte^Capacity of EEPROM|
pcb_manual.txt · Last modified: 2017/07/03 19:26 by z00m